Last time failed, so proceed in the following order.
** Work Goal ** ① Partitioning → Failure ~~ ② Mount ~~ ~~ ③ Capacity limit for each user ~~ ~~ ④ Authority setting ~~ ~~ ⑤ Symbolic link setting at mount point ~~
This time, we will divide it into 3 basic plans + 2 logical partitions. Use the fdisk command to partition the partition until the following status is obtained, as in last time.
Command (m for help): p
Disk /dev/sda: 42.9 GB, 42949672960 bytes, 83886080 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk label type: dos
Disk identifier: 0x0009ef88
Device Boot Start End Blocks Id System
/dev/sda1 2048 10487807 5242880 83 Linux
/dev/sda2 10487808 20973567 5242880 83 Linux
/dev/sda3 20973568 31459327 5242880 83 Linux
/dev/sda4 31459328 83886079 26213376 5 Extended
/dev/sda5 31461376 41947135 5242880 83 Linux
/dev/sda6 41949184 52434943 5242880 83 Linux
After creating and saving the partition, the following error message appears, so I checked it. → I got a lot of information that it will be reflected by restarting.
WARNING: Re-reading the partition table failed with error 16: Device or resource busy.
The kernel still uses the old table. The new table will be used at
the next reboot or after you run partprobe(8) or kpartx(8)
Syncing disks.
After shutting down and vagrant up again, it broke ^^; I don't know the cause, so I put it on hold!
Recommended Posts